EcoProTec Joint Residue Remover softens hard to remove epoxy, acrylic and silicone residues left by cement free brush in jointing compounds making removal easier.

EcoProTec Joint Residue Remover is a low odour non caustic treatment that softens hard to remove epoxy, acrylic and silicone residues left by cement free brush in jointing compounds, thus making removal from the surface of natural stone and porcelain paving much easier.

Directions for use:

Shake well before use and always test on an inconspicuous area prior to general use.

Preparation: Ensure that the surface to be treated is completely clean and dry. If necessary, first wash surfaces with EcoProTec Intensive Cleaner. Rinse well with water to finish and leave to dry.

Removing Residues: Apply generously by dabbing or rolling onto the surface. Work in manageable areas at a time and do not brush out. Leave for up to 30 minutes. If drying should occur within 30 minutes apply a little more solution to keep it wet. Use a stiff short haired brush or nylon scrubbing pad to remove the softened residues from the surface. Add a little water and scrub again. Extract the released residues using a sponge or wet vac and rinse with water. Repeat the process if unwanted material remains.

To finish: Use EcoProTec Intensive cleaner dilute 1: 5 in warm water. Apply with a light pressure sprayer or watering can. Agitate the surface using a deck brush or nylon scrubbing pad. Rinse by hosing off thoroughly with clean water. Do not use when surface temperatures are under 5°C or over 25°C.

Please note:

Do not apply during rain, frost, or when surface and air temp is under 5°C or over 30 °C. Use gloves and protective goggles if there is a risk of direct contact or splashing. Empty containers are recyclable. Clean application tools and brushes with water after use. with

Once cleaned: Protect porous stone and porcelain EcoProTec Ultimate Sealer or Patio Sealer or Colour Enhancing Sealer.

Coverage:
Light Stripping: 8-10m²/Litre
Deep Stripping: 5m²/Litre