Keim Restauro Fixativ is a sol-silicate based binding agent for use with the Keim Restauro Lasur colour wash system (which is available in 250+ colours).

Applies to modern and historic render and stone surfaces, including brickwork and reconstituted stone and any cementitious or lime based mineral substrates in conjunction with the KEIM Restauro Lasur system.

Depending upon the required finish, KEIM Restauro Fixativ is mixed with KEIM Restauro Lasur in any ratio to give a translucent finish. KEIM Restauro Fixativ is also used for priming or pre- fixing.

This product/system requires site trials - Although readily available, please ensure a specification has been issued after site trials have taken place. The colour and degree of dilution affects the final finish and this must be known before purchase.

Please contact our technical team on 01902429190 or email [email protected] for more information. 

Key Features

• Sol-silicate based binding agent
• For use with the Keim Restauro Lasur colour wash system
• Mixes with KEIM Restauro Lasur in any ratio to give a translucent finish, depending upon the required finish
• For application on modern and historic render and stone surfaces, including:
• Brickwork
• Reconstituted stone
• Cementitious or lime based mineral substrates
• Reacts chemically with the surface
• Water vapour permeable
• Consolidates the surface
• Odourless and non-toxic
• Also used for priming or pre-fixing
• Cradle to Cradle Certified Silver

Preparation & Application

Substrate Preparation

All loose, flaking and unstable material must be identified and then thoroughly removed, all surfaces must be thoroughly washed down with clean cold water to remove all surface dirt and dust. When all surfaces are clean, sound, wind dry, dust free and free from all surface contaminants, decoration using KEIM Mineral Paints may proceed.

Application Conditions

Ambient and substrate temperature above 5°C and below 30°C. Do not apply in direct sunlight or onto sun-heated surfaces, nor if it is raining or if there is an immediate likelihood of rain.

Consumption

First Coat:

• KEIM Restauro Fixativ 0.15lt/m2

Finishing coat (KEIM Restauro Lasur, 3:1 ratio)

• KEIM Restauro Lasur 0.04lt/m2
• KEIM Restauro Fixativ 0.11lt/m2

Consumption rates are offered for guideline purposes only and are quoted for smooth rendered surfaces. Actual rates are the responsibility of the applicator. Project specifications should be referred to for specific rates.

Cleaning of Tools

Clean tools with water immediately after use.

Disposal

EC Waste Code EC Waste Code No. 06 02 99

Any residues must be emptied out of containers before recycling.

Data Sheet

Keim Restauro Fixativ TDS