Used in tight feeds not allowing “T” drops. Prevents signal reflection.

Two termination resistors are required on every NMEA 2000 network, one on each end of the trunk line. Normally, a male termination is used since male pins tend to point back to the power source. In cases where the gender is reversed, a female terminator may be required. The inline terminator is used where the network is terminated at a product.

Maretron ITCMCF Attributes

Micro Inline Termination Resistor

The inline terminator is used where the NMEA 2000® network is terminated at a product, for example the top of the mast at a weather instrument or GPS antenna/receiver. The inline terminator plugs directly into the product with the other end connected to the network cable

Micro Termination resistors usually terminate the network by plugging into a tee. The inline terminator doesn't require a tee and easily fits within an instrument's mounting pipe where a tee wouldn't

Rugged, IP-68 rated connectors (submersible) for continued connection integrity in marine environment

Miniature termination resistors usually terminate the network by inserting a tee. The inline terminator does not require a tee, and can be easily installed in the mounting bracket of the instrument...

• Screw terminal connector for positive connections
• Molded Body Mat/Color: Thermoplastic PUR/Black
• Contact Carrier Mat/Color: Thermoplastic PUR/Black
• Contact Mat/Plating: Brass/Gold
• Coupling Nut Mat/Plating: Brass/Nickel

ELECTRICAL:

• Rated Voltage: 10-30 V DC
• Internal Resistor: 121 Ohms (1/4 W)

ENVIRONMENTAL:

• Protection Class: IEC IP68, NEMA 1,3,4,6P
• APPROVALS NMEA: NMEA 2000 APPROVED
• IEC: IEC 61162-3

SKU: NVN-31795
MPN: IT-CM-CF
UPC: 873804001678